Neutrik PowerCON Mains Input 3 Pin 20A Chassis NAC3MPA-1 CONAC3MPA1
Power in, air-tight D chassis connector with flat tab terminals.
The NAC3MPA-1 has a fixed rear cover that cannot be removed, if extra access is required for soldering to the terminals use the NAC3MPA -1-WOT
A Locking 3 conductor equipment AC connector, contacts for line, neutral and pre-mating ground contact.
With a fast and easy locking system and high current capacity (20 A rated) the NAC3MPA-1 is extremely robust and reliable. Meets all prevailing safety standards, UL recognized, VDE certified and SEV approved. Very good cable handling and protection. Note: The PowerCON is a connector without breaking capacity, i.e. the PowerCON should not be connected or disconnected under load or live!
Number of contacts: 3 - for line, neutral and predating safety ground
Rated current per contact: 20 A rms
Rated voltage: 250 V ac
Dielectric strength: 4000 V dc
Chassis shape: D
Wiring: flat tabs for 3/16" (FASTON? 4.8 x 0.5 mm) or soldering
Locking device: quick Lock
Priced per connector: available in any quantity
Packing information: box quantity = 100
With all plastic chassis connectors, if rear mounting using rivets rather than screws for fixing, it is recommended that a washer is used at the rear of the connector to spread the load rather than let the rivet dig into the plastic.
NAC3FCA and NAC3MPA-1 are used for power in to a unit
NAC3FCB and NAC3MPB-1 are used for power out of a unit
Power-in (blue) and power-out (grey) versions with different keying to avoid the possibility of intermating. Branded with unique hologram - guarantees genuine and authentic Neutrik product