First-AV.co.uk LED Emergency Power Pack Version 2 LEDEMPV2 LEDEMPV2
The emergency power pack can be used with any LED product that has an external driver and a power consumption smaller than 100 W.
The EMP reduces the output power automatically when it is under the emergency condition. Over current, short circuit, battery low-voltage protection and battery low-voltage alarm function included.
Whenever there is a black out, the emergency driver will switch automatically to the emergency mode. The LED product connected to it will operate at a reduced lumen output for a minimum of 90 minutes. When power is restored, the emergency driver will return to charging mode (fully recharged in 24 hours). The emergency driver does not affect the normal operation of the fixture and it is suitable for indoor and damp locations.
Intelligent management of battery charge, the battery will be charged and discharged automatically to keep it active
The power wattage under emergency mode can be adjusted, the current can be adjusted by a small knob on the emergency driver to match different voltages of the power supply (from 18 to 59 V)
Driver and battery integration system design
Short-circuit protection under emergency mode
Test switch on emergency driver allows testing the performance of emergency driver under normal working conditions. It also can turn off the emergency function under emergency mode by a long press of the testing switch.
Emergency condition mode (Battery mode)
Max input current = 500 mA
Emergency time > 90 min
Battery specification = 14.4V / 2000 mAh
Output Voltage = 18 - 59 Vdc
Max output power <= 10 W
Normal operation mode (AC mode)
Max output power 100 W
Input Voltage 100-277 Vac
Input Frequency 50/60 Hz
Max charging power <= 7 W
External input voltage 24 - 60 V
External input current 2 A
Module dimensions: (L x W x H) 320 x 46 x 33.5 mm
Warranty: 2 years
Product colour: Red